Microstructure and flexural strength of the Y:TZP/BG composite

The addition of bioactive glasses to a Y:TZP matrix represents a feasible alternative to provide bioactivity to this material and optimize osseointegration. This work evaluated the effect of the BG concentration (0 and 10 wt%) and the sintering temperature (1200°C and 1300°C) on the microstructure, relative density, and flexural strength of the composite Y:TZP/BG. The Y:TZP and Y:TZP/BG powders were uniaxially pressed and sintered at 1200°C or 1300°C for 1 h. The microstructure was characterized by X-ray diffraction analysis, scanning electron microscopy, and energy-dispersive X-ray Spectroscopy. Relative density was calculated from density values obtained using the Archimedes’ principle. For the flexural strength, specimens (n = 6) were fractured in a biaxial flexural setup using a piston-on-three-balls fixture in a universal testing machine. Bioactivity test was performed in simulated body fluid solution. The results suggested that BG addition decreased the grain size of the composite, increased porosity and caused a significant decrease in the relative density and flexural strength. Crystalline phases of calcium stabilized cubic zirconia and sodium zirconium silicate were formed after the addition of BG. Finally, it was concluded that composite specimens sintered at 1300°C showed the highest density values and larger grains compared to those sintered at 1200°C.     

基于(火用)效率目标的环冷机余热回收系统操作参数优化

摘要：针对烧结环冷机余热回收利用率不高的难题，采用分析法建立了评价某钢铁厂烧结环冷机余热回收系统运行效率的效率模型。基于多孔介质模型、局部非热平衡方程、真实气体SRK方程建立环冷机内气固两相换热模型。通过CFD仿真模拟，探究料层高度、循环风机输入烟气温度、烧结矿底部入口风速三项可控环冷机运行工艺参数对系统效率的影响规律。结果表明，料层厚度在1～1.5 m区间每增加0.1 m，效率增加0.8%～1.1%；循环风温在100～140℃之间每增加10℃，效率增加1.4%～1.5%；烧结矿底部入口风速在0.9～1.9 m/s之间每增加0.1 m/s，效率降低0.18%～0.24%。在此基础上，基于工业运行数据建立效率正交试验优化模型，提高了该余热回收系统3.42%的效率。     

高伸长率冷轧双相钢DP980显微组织及性能

摘要：为了进一步提高冷轧双相钢DP980的强塑性，采用低C-Si-Mn-Nb-Cr成分，通过调整连续退火工艺参数，系统研究了工艺组织性能的关系，利用OM、SEM、EBSD分析了不同退火温度条件下各相的比例、尺寸、形貌、分布，同时利用力学拉伸试验手段研究了连退两相区退火温度对强塑性的影响。结果表明，通过优化调整连续退火工艺，不仅可以在冷轧铁素体和马氏体双相钢的组织上获得少量的残余奥氏体，也能细化再结晶晶粒，最终获得ReL/Rm≤0.5、高伸长率A50≥15%的冷轧DP980，提高强塑性的同时改善了成型性能。     

CO_2 conversion by thermal plasma with carbon as reducing agent: high CO yield and energy efficiency

A key problem in CO_2 conversion by thermal plasma is suppressing the inverse reactions,CO?+?O?→?CO_2 and CO?+?0.5O_2?→?CO_2, to simultaneously obtain high CO yield and energy efficiency. This can be done by quickly quenching the decomposed gas or rapidly taking away free oxygen from decomposed gas. In this paper, experiments of CO_2 conversion by thermal plasma with carbon as a reducing agent are presented. Carbon quickly devoured free oxygen in thermal plasma decomposed gas, and not only is the inverse reaction completely suppressed, but the discharge energy to form oxygen atoms, oxygen molecular, and thermal energy is also reused.A CO_2 conversion rate of 67%–94% and the corresponding electric energy efficiency of about 70% are achieved, both are much higher than that seen so far by other plasma implementations.     

电感耦合等离子体原子发射光谱法测定辛酸铑催化剂中铂钯铅铁铜铝镍

准确测定辛酸铑催化剂中杂质元素含量,是判定产品是否合格的重要指标之一。以往常采用直流电弧发射光谱法(摄谱法)进行检测,但测定周期长,且重复性较差。用电感耦合等离子体原子发射光谱法(ICP-AES)测定辛酸铑催化剂中微量杂质元素时,辛酸铑催化剂样品中含有的大量有机组分和铑基体会对测定有严重干扰。实验采用反复滴加硝酸消解样品中有机组分,再用王水溶解盐类,选用合适背景点扣除的方式消除铑基体的干扰,建立了使用ICP-AES测定辛酸铑催化剂中0.001%~0.1%(质量分数)Pt、Pd、Pb、Fe、Cu、Al、Ni等7种微量杂质元素的方法。各元素在0.10~10.00μg/mL范围内与其发射强度呈线性关系,相关系数均大于0.9999;方法检出限(μg/mL)为0.075(Pt)、0.0033(Pd)、0.015(Pb)、0.0036(Fe)、0.010(Cu)、0.001(Al)、0.012(Ni)。实验方法用于测定辛酸铑催化剂样品中Pt、Pd、Pb、Fe、Cu、Al、Ni,结果的相对标准偏差为(RSD,n=7)为1.4%~9.6%。按照实验方法测定辛酸铑催化剂中Pt、Pd、Pb、Fe、Cu、Al、Ni,并与直流电弧发射光谱法的测定结果进行比对,结果相一致。     

Q700D热影响粗晶区疲劳寿命与小裂纹扩展分析

摘要：为提高焊接构件的动载疲劳寿命，以热模拟为试验手段，对Q700D高强钢进行了焊接热模拟，研究了粗晶热影响区的疲劳寿命、小裂纹扩展行为以及组织软化特征。利用Paris方程和轴向拉伸疲劳试验数据，建立了ΔKth值与模拟粗晶区疲劳寿命的对应关系，利用ΔKth值实现了快速预估粗晶区疲劳寿命。研究表明：相同应力幅值下的lgN值与ΔKth值存在一定的线性拟合关系，即ΔKth值越大，则疲劳寿命N越长。小裂纹扩展微观机理在于所形成的大角度晶界（不小于15°）对小裂纹尖端的止裂性较强，可迫使小裂纹尖端转向耗能。CGHAZ的软化与第二相粒子回熔与粗化有关，粗化的第二相粒子易萌生小裂纹，可通过提高大角度晶界抑制裂纹扩展。     

Self-consistent kinetic theory with nonlinear wave-particle resonances

We have developed, based on the oscillating-center transformation, a general theoretical approach for self-consistent plasma dynamics including, explicitly, effects of nonlinear(higherorder) wave-particle resonances. A specific example is then given for low-frequency responses of trapped particles in axisymmetric tokamaks. Possible applications to transport as well as nonlinear wave growth/damping are also briefly discussed.